www.fisher-price.comBouncerCover’n Play™Model Number: 79619Please keep this instruction sheet for future reference,as it contains important informatio
• Fit the toy bar plugs into each retainer socket.• Unfasten a strap on the toy bar.• Wrap the strap around a toy ring and re-fasten the strap.• Repea
11Set-Up & UseTo prevent serious injury and/or falls:• Never use on any elevated surface,since child’s movement may causebouncer to slide or tip o
LoosenTo tighten the restraint:• Feed the anchored end of the belt up through the buckle toform a loop .• Pull the free end of the belt .• Repeat th
413Set-up & Use• Pull the blanket down completely.• Fold the blanket under the footrest wire.• Tuck the blanket into the pocket on the underside o
The pad is machine washable.Wash it separately in cold water onthe gentle cycle. Do not use bleach.Tumble dry separately on lowheat and remove promptl
FCC Note (United States Only)Note: This equipment has been tested and found to comply withthe limits for a Class B digital device, pursuant to Part 15
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.©2001 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademark
2WarningTo prevent serious injury and/or falls:• Never use on any elevated surface,since child’s movement may causebouncer to slide or tip over.• Neve
Parts3#8 x 3/4" Screw - 23 ToysToy BarPadFootrestSeat BackTubeRetainerRetainerRight Base WireLeft Base WireBase TubeShown Actual Size
• Locate the soothing unit on the footrest.• Insert a coin into the battery compartment door and pry the batterycompartment door off.• Insert one “D”
• Place the base tube on a flat surface as shown.• Position the left and right base wires as shown. Note the locationof the colored tabs on the left a
• Position the footrest so that the soothing unit is upright.• While flexing the base wires toward each other, hook the footrest onto the ends of the
• Position the seat back tube above the base assembly.• Fit the seat back tube completely onto the base wires.Assembly37Seat Back TubeBase WireBase Wi
• Fit a retainer to the outside of theseat back tube, as shown. Make surethe socket in the retainer is upright.• Insert a screw through the hole inthe
• Position the pad above the frame with the blanket toward thesoothing unit.• Fit the upper pocket on the back of the pad onto the seat backtube .• L
Comments to this Manuals