Fisher-Price P0098 Instruction Sheet

1www.fi sher-price.comP0098www.fi sher-price.com

10• First, fit an M5 lock nut into an opening in the short tube. Make sure the rounded side of the lock nut faces out.• Next, insert an M5 x 28 mm bol

11• First, fit an M5 lock nut into an opening in the upper seat tube. Make sure the rounded side of the lock nut faces out.• Next, insert an M5 x 28 m

12• Loosen the screws in the battery compartment door with a Phillips screwdriver and remove the battery compartment door.• Insert four “D” (LR20) alk

13In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product. To avoid battery leakage:• Do no

14TrayPlateauBandejaUsing the Tray• “Snap” the tray onto the seat handles.• To remove the tray, pull one edge of the tray out and lift.Pour utiliser l

15LOOSENDESSERRERDESAJUSTARAnchored EndExtrémité fixeExtremo fijoAnchored EndExtrémité fixeExtremo fijoTIGHTENSERRERAJUSTARFree EndExtrémité libreExtr

16You can adjust the seat to two different positions: Recline or Upright.• From behind the seat, press both seat position buttons.• Push the seat back

17Mobile ONMobile en marcheMóvil ACTIVADOMusic/Sounds SwitchInterrupteurmusique/sonsInterruptor demúsica/sonidosMobile SwitchInterruptordel MóvilBouto

18Hints: • As with most battery-powered swings, a heavier child will reduce the amount of swinging motion on all settings. In most cases, the low sett

19• Lean the swing frame against a wall for storage.IMPORTANT! Remove the batteries for long-term storage.Hint: The legs may be disassembled for long-

2• To prevent serious injury or death from falls and being strangled in the restraint system:– Always use restraint system. Never rely on the tray to

20SleeveFundaOurletCare Entretien Mantenimiento• Remove the top of the canopy from the clip on swing tube A. Pull the ends of the canopy stay

21Problems and SolutionsTurn the power dial to one of six settings.Remove the batteries and replace in correct orientation, as indicated inside the ba

22Tourner le cadran d’alimentation à l’une des six positions.Retirer les piles et les remettre en bonne position,comme illustré dans le compartiment d

23Solución de problemasColocar el botón de encendido en uno de los seis valores.Sacar las pilas y colocarlas correctamente, como se indicadentro del c

Fisher Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.©2008 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademark

3Consumer Information Renseignements pour les consommateursInformación para el consumidorIMPORTANT! Please keep these instructions for future refe

42 Lower Legs2 sections inférieures de montants2 patas inferiores Motorized Frame Boîtier du moteur Armazón motorizadoPad with Headrest and CanopyCou

5• Position a lower leg so that it stands on a flat surface, as shown.• Fit a foot onto the end of the lower leg.• Insert a #8 x 3/4" (1.9 cm) sc

6• Locate the R and L on the underside of each elbow foot. The R indicates the right leg. The L indicates the left leg.• While pressing the upper butt

7SeatSiègeAsiento• Fit the side rails to the side tabs on the seat.• Insert four #10 x 3/4" (1.9 cm) screws into the side rails. • Fully tighten

8• Turn the seat face down.• Fasten both straps on the pad and seat.• Hook both elastic loops at the top of the seat pad around the pegs at the top of

9• Fit the pad edges around the rim of the seat.• Fit the pad around the seat handles.• Placer les bords du coussin sur le rebord du siège.• Fixer le