Fisher-price BOUNCE N GO G4815 User Manual

G4815InstructionsBounce ‘n Go™CoupePlease read these instructions carefully and identify all parts before assembly. Refer to the parts and fasteners p

1026• Fit the sound box inside the center of the steering wheel.Assembly27• Fit the top edge of the sound box cover into the groove in the steering wh

11Assembly30• Insert the upper post into the lower post.31• Fit the grip halves to the post assembly, over the latch halves.• Insert three #6 x 1/2&qu

1232• Position the post so that the lower bend is toward the front end of the coupe.• Insert the post into the column on the back of the coupe.33• Ins

13Seat Adjustment• Place the seat onto the coupe into either of two positions – frontor back .• Have your child sit on the seat and check the dis

14• Locate the sliding latches inside the bouncing base/spoiler. While lifting both sliding latches on the bouncing base/spoiler , rotate the boun

15• Locate the sliding latches inside the bouncing base/spoiler. While pushing both sliding latches on the bouncing base/spoiler down ,rotate the boun

Care• Wipe this toy with a clean cloth dampened with a mild soap and water solution. Do not immerse this toy. • Do not leave this toy outside in the r

2PartsHandle/CanopyNotes: • Some parts shown are assembled toboth sides of the coupe.• Please save all packaging material untilassembly is complete to

3Warning and CautionCAUTIONWARNINGTo avoid serious injury:• Adult supervision required. • Never use near cars and other motor vehi-cles, near streets,

41• Place the frame upside down on a flat surface. Make sure the steeringlinkage assembly is fitted to the front end of the frame.• Remove the tape ho

55• Fit an axle cover over the cap nuts and to the front end of the frame.Push down on the axle covers to “snap” them into place.Hint: You may need to

69• Fit a .354" cap nut onto the end of the front axle.• Cover the cap nut with the assembly tool. Tap the cap nut assemblytool with a hammer to

713• Slide the smooth end of the rear axle into the hole in one side of thebouncer base/spoiler, a frame bushing, the frame, the other framebushing an

817• Fit an axle cover to the large, rear wheel, as shown.• Push the axle cover to “snap” it into place.Hint: You may need to carefully tap the axle c

9Assembly21• Lift the front end of the vehicle.• Insert the straight end of the steering column up through the hole inthe frame.23• Fit the steering w