www.fisher-price.comBouncerKick & PlayModel Number: B8865IMPORTANT! KEEP FOR FUTURE REFERENCE.Please read these instructions before assembly and u
55Assembly10•Unbuckle the restraint belts from the restraintpad. Push the restraint belts back through the slots in the pad .•Fit the pad upper pocke
Assembly11•Fit both restraint belts back through the pad slots, as shown.56RestraintBelts
Assembly12•Fit the ends of the toy bar into the sockets in the footrest.Assembly is now complete.•The toy bar is removable. Simply lift up to remove.H
Set-Up & Use13Securing Your Child•If the toy bar is attached, remove it before placing your child in the seat.•Place your child in the seat. Posit
To tighten the belts:•Feed the anchored end of the belt up through the buckle to form a loop .•Pull the free end of the belt .•Repeat this procedur
Baby Activated•Slide the mode switch to for baby activated mode.•When baby kicks a footrest button, baby is rewarded with sound effectsand chasing lig
Set-Up & Use16•The teethers are removable from the toy on the toy bar. Simply twist theends of each teether slightly to remove them from the centr
To prevent serious injury or death:• It is dangerous to use this reclined cradle on anelevated surface.•Never use on a soft surface (bed, sofa, cushio
Parts3PadToy BarRemovableTeether RingsFootrest withSoothing Unit2 RetainersSeatBackTubeRight Base WireLeft Base WireBase Tube#8 x 2 cm (3/4") Scr
•Loosen the screw in the soothing unit battery compartment door with aPhillips screwdriver. Remove the battery compartment door.• Insert one LR20 (“D”
Battery Safety InformationBatteries may leak fluids that can cause a chemical burn injury or ruin yourproduct. To avoid battery leakage:•Do not mix ol
Assembly6•Place the base tube on a flat surfaceas shown.•Position the left and right base wires asshown. Note the locations of the colouredtab on the
•Position the footrest so that the soothing unit buttons are upright.•While flexing the base wires toward each other, hook the footrest onto theends o
Assembly8•Position the seat back tube so that it bends backward.•Fit the seat back tube completely onto the base wires. Make sure the holein each end
Assembly9•Pull up on the seat back tube to be sure it is secure. If you can removeeither end of the seat back tube, you have not assembled it correctl
Comments to this Manuals