Fisher-Price P4259 Instruction Sheet

www.fisher-price.comP4259

10AssemblyHint: The shoulder belts come assembled to the seat back in the lower position for a smaller child. To change to the upper slots for a large

11Fit the elastic loops on the seat pad down through the slots in • the footrest. 21Elastic Loops SlotsAssemblyFit the elastic loops on the seat pad b

12AssemblyFit the upper pocket of the seat pad onto the seat back. • Fit the ends of the waist belts through the clips on the • shoulder belts.2423Sh

13Securing Your ChildPlace your child in the seat. Position the crotch belt between your • child’s legs.Fasten both waist/shoulder belts to each side

14• To tighten the waist belts: Feed the anchored end of the waist belt up through the buckle to form a loop A. Pull the free end of the waist belt B

15To adjust the restraint height for baby, push to remove the • shoulder belts from the seat back.5Shoulder Belts Smaller BabyInsert the ends of the s

16Adjusting Seat ReclineHint: Adjust the seat angle to any of three positions: Upright, Semi-Recline or Recline. Lift the seat back latch and push the

17Using the TraysSlide the snack tray onto the seat armrests. Push the snack tray • until it "snaps" into place.Fit the food tray onto the s

184To remove the snack tray, pull the tabs on the sides of the snack • tray off the pegs. Slide the tray off of the armrests. • While pulling the rele

19CareThe snack tray, seat and restraint straps may be wiped clean • using a mild cleaning solution and damp cloth. Do not use bleach. Do not use hars

2This package contains small parts in its unassembled state. Adult assembly is required.Prevent serious injury or death from falls or sliding out.• T

CANADAMattel Canada Inc., 6155 Freemont Blvd., Mississauga, Ontario L5R 3W2.Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, New York 14

32 Front Legs 2 Back Legs Footrest PartsAll Fasteners Shown Actual SizeTighten the screws with the enclosed Allen wrench. Back BaseSeat Back with Shou

4Turn the seat bottom upside down on a flat surface. • Position a back leg so that it curves up and fit it into a large • socket in the seat bottom.

5Position a front leg so that it curves up and fit it into the small • socket in the seat bottom. Hint: If the leg does not seem to fit into the seat

6AssemblyFit the back base onto the bottom of both back legs, as shown. • Insert two M6 x 28mm screws into• each back leg and tighten.Fit the socket

7AssemblyLift the seat back latch and push the seat back forward.• 1413Seat BackPegHolesAt an angle, fit the pegs on each side of the seat back into t

8Insert two M4 x 17mm screws into the seat back and tighten.• Fit a seat bracket to the side of the seat bottom, as shown.• Insert two M4 x 17 mm sc

9AssemblyFit the other seat bracket to the other side of the seat bottom, • as shown.Insert two M4 x 17 mm screws and tighten.• 17M4 x 17mm ScrewsSeat