Discoverwhat’spossible™…www.fisher-price.comModel Number: B1637Please keep this instruction sheet for future reference, as it contains important infor
Assembly10• Position the lights ‘n sounds tray on a flat surface, with theroller facing you.• Position the mirror base, with the mirror toward you.• F
11• When swinging, sounds or lights slows/dims/stops, it’s timeto change the batteries!• Do not mix old and new batteries.• Do not mix different types
IMPORTANT! Before each use, inspect this product for damaged hardware, loose joints, missing parts or sharp edges.DO NOT use if any parts are missing
Tray13Adjust the seat angle in any of three positions:Upright, Semi-Recline or Recline.To adjust the seat angle:• Push down on the seat back to positi
SwingingHint: As with most battery-powered swings, a heavier child reduces the amount of swinging motion onall settings. In most cases, the low settin
CareStorage• Fit the bottom of the remote into thecupped portion of the holder.• Push to “snap” the top of the remoteunder the holder clips.• Press th
For Best ResultsFCC Statement (United States Only)• Make sure the remote is no further away than 25 feet fromthe swing.• Make sure the remote and the
Warning and Caution Consumer Information2Occasionally a consumer may experience a problem withone of our products. If this should happen, please call
Parts3Front BaseRear BaseHousing2 Rear Legs(Shorter)Motor HousingSeat with Restraint2 Seat TubesBracketSeat Wire2 Seat WireCaps2 Accessory BinsPadSoun
• Place the front base on a flat surface.• Position a front leg (longer) so that the tapered end isdownward, as shown.• While pressing the button on o
Assembly5• Position a rear leg so that the tapered end is upright.• While pressing the button on the top of the rear leg, insert itinto the housing sh
• Place the rear base on a flat surface so that the buttons face the front base.• While pressing the buttons on each side of the rear base,fit the rea
• Insert four M4 screws through theseat tubes, bracket and into the lock nuts.• Tighten the screws with a Phillips screwdriver.Do not over-tighten.Ass
• While holding the seat wire in place, carefully turn the seat around so that the front of the seat faces you.• Position the seat wire cap so that th
Assembly• Fit the pocket on the back of the pad onto the seat back.• Fit the waist belts through the smaller slots in the pad.9Waist BeltsPadSlotSlot2
Comments to this Manuals